To Next PageTo Next Page
Need help?Do you have a question about the DeWalt D28402N and is the answer not in the manual?
General| Power Source | Corded Electric |
|---|---|
| Spindle Thread | 5/8 in - 11 UNC |
| Height | 4.5 in |
| AC/DC | AC |
| Wheel Arbor | 5/8 in |
| Power Input | 1200 W |
| Amperage | 10 A |
| No Load Speed | 10000 rpm |
| Length | 12.5 in |
| Switch Type | Slide |
Keep work area clean and well lit. Avoid explosive atmospheres. Keep bystanders away.
Grounded tools must be plugged into properly installed and grounded outlets. Double insulated tools have polarized plugs.
Avoid contact with grounded surfaces. Protect tools from rain/wet. Do not abuse cords. Use proper extension cords.
Stay alert, dress properly, avoid accidental starting, remove tools, maintain balance, use safety equipment.
Secure workpiece with clamps, use correct tool, ensure switch functions properly.
Check grinding wheel backing flange for yellow rubber ring. Replace if missing or damaged.
Kickback is a sudden reaction to pinched, bound, or misaligned wheels.
Maintain firm grip, position body, release trigger when binding, restart carefully, support panels.
Direct sparks away. Use side handle. Avoid wiring/piping. Clean tool often. Limit operation time. Direct DES away.
Explanation of symbols used on the tool label.
Lists and identifies all components of the tool with reference to Figure 1.
Attaching the side handle to the gear case.
How to rotate the gear case for desired position.
Importance of choosing correct guards, backing pads, and flanges for grinder accessories.
Illustrates and names components for 4-1/2" grinding wheels.
Illustrates and names components for wire wheels.
Instructions for mounting and removing the guard for specific models.
Illustrates and names components for 4-1/2" cutting wheels.
Illustrates and names components for sanding discs.
Illustrates and names components for 4-1/2" sanding flap discs.
Step-by-step guide for mounting, securing, and removing the guard.
Steps for mounting, securing, and removing the guard specific to the D28110 model.
Importance of choosing correct guards and flanges for grinder accessories.
Safety precautions and operation of different switch types.
How to operate the paddle switch and lock-off lever.
Instructions for using the slider switch for various operational modes.
Explanation of the lock-on button for comfort in extended use.
Procedure to operate the spindle lock for installing/removing wheels.
Steps for mounting and removing hubbed wheels.
Steps for mounting non-hubbed wheels.
Detailed steps for installing Type 27 grinding wheels with flanges.
How to perform surface grinding with grinding wheels.
Guidelines for edge grinding and cutting with grinding wheels.
How to perform surface finishing with sanding flap discs.
Instructions for mounting sanding backing pads.
Guidance on selecting the appropriate sandpaper grit.
Ensure tool reaches full speed before contact with work.
Steps for mounting wire cup brushes and wire wheels.
Techniques for using wire brushes and wheels.
Instructions for mounting the closed Type 1 guard.
Steps for mounting cutting wheels.
How to use cutting wheels safely and effectively.
Recommended cleaning procedures for the tool.
Information on tool lubrication.
Guidance on product repairs and service.
Information on recommended accessories.
Details on free service for the first year.
Information on the 90-day money-back guarantee.
How to get replacement warning labels.
