To Next PageTo Next Page
Need help?Do you have a question about the DeWalt D28402 and is the answer not in the manual?
General| No Load Speed | 11, 000 RPM |
|---|---|
| Spindle Thread | 5/8"-11 |
| Tool Length | 12" |
| Wheel Diameter | 4-1/2" |
| Voltage | 120 V |
| AC/DC | AC |
| Amperage | 10 A |
Defines signal words like DANGER, WARNING, CAUTION, and NOTICE based on severity.
Ensures a safe environment by keeping work areas clean and well-lit, and preventing distractions.
Guidelines for safe use of electrical power tools, including plug matching and cord care.
Focuses on operator alertness, protective equipment, and preventing unintentional starts.
Advice on selecting the correct tool, proper maintenance, and safe storage practices.
General safety precautions applicable to various grinding and finishing tasks.
Explains kickback causes and provides precautions to avoid it.
Safety advice for using grinding and cutting wheels, including guard usage.
Emphasizes wearing safety glasses, dust masks, and hearing protection for various operations.
Lists and labels the various parts of the angle grinder, including switches and guards.
Defines the intended use of the angle grinders for professional grinding and specifies restrictions.
Warning to turn off and disconnect power before assembly or adjustments to prevent accidental start-up.
Illustrates different types of grinding wheels and wire wheels, and their guards.
Step-by-step guide to rotating the gear case for different working positions.
Details cutting wheels, sanding discs, and flap discs, including their mounting requirements.
Highlights the importance of matching accessory speed ratings and arbor holes to the tool.
Instructions for attaching, adjusting, and removing the protective guard for safety.
Reminder to turn off and disconnect power before any accessory installation or adjustment.
Guide on using the paddle switch, lock-off lever, and lock-on button for tool control.
Instructions for operating the slider switch for turning the tool on and off.
Explains how to use the lock-on button and spindle lock for tool control and accessory changes.
Steps for mounting Type 27 grinding wheels using backing flanges and clamp nuts.
Instructions for mounting wheels with threaded hubs onto the spindle.
Technique for surface grinding, including speed, pressure, and angle guidance.
Technique for edge grinding, cautioning against bending wheels and using proper guards.
Guidance on using sanding flap discs for surface finishing, including angle and pressure.
Steps for mounting sanding backing pads and discs onto the spindle.
Advice on selecting sandpaper grits and using sanding pads for optimal finish.
Instructions for mounting wire brushes and wheels without flanges, and required guards.
Techniques for using wire brushes and wheels for cleaning and smoothing.
Instructions for mounting Type 1 cutting wheels, emphasizing the need for a closed guard.
Detailed steps for mounting and adjusting the closed Type 1 guard for cutting wheels.
Steps for mounting cutting wheels using backing flanges and clamp nuts.
Guidance on using cutting wheels, including speed, pressure, and angle.
Instructions for cleaning the tool's air vents and exterior using approved safety equipment.
Emphasizes using only DEWALT recommended accessories for safety and reliability.
Recommends using authorized DEWALT service centers for repairs and maintenance.
Details benefits of product registration, including warranty service and safety notifications.
Outlines the three-year limited warranty, free service, and money-back guarantee.
