DeWalt DC733K

9
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Use only with DEWALT battery packs,
others may burst, causing personal injury
and damage
Do not expose to water
Have defective cords replaced
immediately
+40 ˚c
+4 ˚c
Charge only between 4 oC and 40 oC
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Package contents
The package contains:
1 Cordless drill/driver
1 Charger
2 Battery packs
1 Screwdriver bit
1 Kitbox (K-models only)
1 Instruction manual
s Check for damage to the tool, parts or
accessories which may have occurred during
transport.
s Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. 1)
Your cordless drill/driver DC740
DC733
// DC750 has
been
designed for professional drilling and
screwdriving
applications.
a Variable speed switch
b Forward/reverse slider
c Keyless chuck
d Mode selector/torque adjustment collar
e Collar settings
f Two gear selector
g Ventilation slots
h Grip
i Battery pack
Charger
i Battery pack
j Release buttons
k Charger
l Charging indicator (red)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your DEWALT charger is double
insulated in accordance with EN 60745.
Mains plug replacement
(U.K. & Ireland only)
s Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D
EWALT repair agent or a qualified electrician.
s Disconnect the plug from the supply.
s Cut off the plug and dispose of it safely; a plug
with bared cop
per conductors is dangerous if
engaged in a live socket outlet.
s Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
Your DE9116 charger accepts D
EWALT NiCd and
NiMH battery packs ranging from 7.2 V to 18 V.
Your DE9118 charger accepts D
EWALT NiCd battery
packs ranging from 7.2 V to 14.4 V.
The DE9135 charger accepts 7.2 to 18 V NiCd,
NiMH or Li-Ion batteries.
These chargers require no adjustment and are
designed to be as easy as possible to operate.
ENGLISH