EasyManuals Logo

DeWalt DCCS674 User Manual

DeWalt DCCS674
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
ENGLISH
18
DCCS674 TROUBLESHOOTING
Problem Solution
Unit will notstart. Check batteryinstallation.
Check battery chargingrequirements.
Press the On/Off button before squeezing the lock
off lever and trigger switch.
Check that chain brake is disengaged.
Disengage the chain brake/front hand guard. Pull
the chain brake/front hand guard towards the
front handle into the set” position as shown in
Fig.O. Restart the unit.
Check that lock off lever is fully pushed forward
prior to moving trigger switch.
Unit shuts down
inuse.
Chargebattery.
Unit is being forced. Restart and apply lesspressure.
Battery
won’tcharge.
Insert battery into charger until red charging light
illuminates. Charge up to 8 hours if battery is
totallydrained.
Plug charger into a working outlet. Refer
to Important Charging Notes for
moredetails.
Check current at receptacle by plugging in a
different appliance.
Check to see if receptacle is connected to a light
switch which turns power off when you turn out
thelights.
Move charger and appliance to a surrounding air
temperature of above 40°F (4.5°C) or below
104°F (40.5°C).
Bar /
Chainoverheated.
Refer to Adjusting Chain Tensionsection.
Refer to Chain Oilingsection.
Chain isloose.
Refer to Adjusting Chain Tensionsection.
Poor cutquality.
Refer to Adjusting Chain Tensionsection.
NOTE: Excessive tension leads to excessive wear
and reduction in life of bar and chain. Lubricate
before each cut. Refer to Replacing the Saw
Chainsection.
Unit runs but does
notcut.
Chain could be installed backwards. Refer to sections for
Installing and Removing Chain.
Unit does notoil. Refill oilreservoir.
Clean guide bar, sprocket and sprocket cover. Refer
to Care And Maintenancesection.
Two Year Commercial Warranty
For warranty terms, go to https://www.dewalt.com/
support/warranty.
To request a written copy of the warranty terms, contact:
Customer Service at D
eWALT Industrial Tool Co., 701East
Joppa Road, Towson, MD 21286or call 1-800-4-DeWALT
(1-800-433-9258).
LATIN AMERICA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country‑specific warranty information contained in
the packaging, call the local company or see website for
warrantyinformation.
FREE WARNING LABEL REPLACEMENT: If your warning
labels become illegible or are missing, call 1-800-4-
DeWALT
(1-800-433-9258) for a freereplacement.
Register Online
Thank you for your purchase. Register your product nowfor:
WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
CONFIRMATION OF OWNERSHIP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof ofpurchase.
FOR YOUR SAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer SafetyAct.
Register online at www.dewalt.com.
Repairs
The charger and batteries are notserviceable. There are no
serviceable parts inside the charger or batterypack.
WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including
brush inspection and replacement, when applicable)
should be performed by a factory service center or
an authorized service center. Always use identical
replacementparts.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DCCS674 and is the answer not in the manual?

DeWalt DCCS674 Specifications

General IconGeneral
BrandDeWalt
ModelDCCS674
CategoryChainsaw
LanguageEnglish

Related product manuals