Need help?Do you have a question about the DeWalt dcd733 and is the answer not in the manual?
General| Chuck Size | 1/2 inch |
|---|---|
| Clutch Settings | 15 |
| Speed | 0-1, 500 RPM |
| Battery Type | Li-ion |
| Type | Cordless Drill/Driver |
Indicates an imminently hazardous situation that will result in death or serious injury if not avoided.
Indicates a potentially hazardous situation that could result in death or serious injury if not avoided.
Do not operate power tools in atmospheres with flammable liquids, gases, or dust.
Water entering a power tool increases the risk of electric shock.
Wear eye protection, dust mask, safety shoes, hard hat, or hearing protection.
Use the correct power tool for your application for better and safer results.
Using other battery packs may create a risk of injury and fire.
Exposure to noise can cause hearing loss.
Do not allow liquid inside charger; electric shock may result.
Charge only DEWALT battery packs; others may overheat or burst.
Charger and battery pack are designed to work together.
Steps for plugging in the charger and inserting the battery pack.
Explains the meaning of charging lights and indicates faulty battery/charger.
Suspends charging until battery reaches appropriate temperature for optimal life.
Damaged packs should not be used; return for recycling.
Ignition of dust or fumes may occur when inserting/removing pack.
Battery pack can explode in fire; toxic fumes are created.
Modification can result in damage or personal injury.
Designed for professional drilling, percussion drilling and screwdriving.
Avoid operation in hazardous environments.
Ensures tool is de-energized before performing maintenance.
Aligns and slides the battery pack into the tool handle until seated.
Damage to chuck and personal injury may result.
Always use proper hand position as shown for safety.
Anchor or clamp workpiece firmly; use wood block for thin material.
Start with lower torque settings to avoid damaging workpiece or fastener.
Disconnect tool before adjustments or accessory changes to prevent accidental start-up.
Disconnect charger from AC outlet before cleaning to avoid shock hazard.
Use only DEWALT recommended accessories for safety.
Recycle Li-Ion cells through dealers or local recycling stations.
To Next Page
