14
English
4. When drilling deep holes, if the hammer speed starts to drop off,
pull the bit partially out of the hole with the tool still running to help
clear debris from the hole.
NOTE: A smooth, even flow of dust from the hole indicates proper
drilling rate.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk of eye
injury, always wear ANSI Z87.1 approved eye protection when
performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Accessories
WARNING: Since accessories, other than those offered by
D
EWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
EWALT recommended accessories should be used with
this product.
Recommended accessories for use with your tool are available at
extra cost from your local service center. If you need any assistance
in locating any accessory, please contact D
EWALT Industrial Tool Co.,
701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-D
EWALT
(1-800-433-9258) or visit our website: www.dewalt.com.
MAXIMUM RECOMMENDED CAPACITIES
DCD980 DCD985
WOOD
Auger
1-1/4" (32 mm) 1-1/4" (32 mm)
Paddle
1-1/2" (38 mm) 1-1/2" (38 mm)
Twist
1/2" (13 mm) 1/2" (13 mm)
Self-feed
2-9/16" (65 mm) 2-9/16" (65 mm)
Hole saw
4" (100 mm) 4" (100 mm)
METAL
Twist
1/2" (13 mm) 1/2" (13 mm)
Hole saw
1-3/8" (35 mm) 1-3/8" (35 mm)
MASONRY
Carbide
– 1/2" (13 mm)
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
To Next Page
Loading...
Need help?
General
