H
H
FUNCTIONAL CHECK:
A customer may come in with a complaint that the drill is
drilling in clutch mode or clutching out in drill (or hammer)
mode. In either case the following flowchart should be
followed to ensure that the drill is functioning correctly
before disassembly.
To better diagnose our new eClutch and related sensors.
We have assembled an initial diagnostic flowchart to better
pinpoint the root cause of a potential customer complaint.
ELECTRICAL CHECK:
Remove housing and gearcase screws, opening up and removing cover side handle. Carefully
remove Transmission Front End and Module/Motor together as one full unit.
Inspect all wires for pinches, nicks, or cuts. Anything abnormal can effect function.
This next step is to interrogate the electrical inputs and outputs from Clutch Position Sensor (CPS)
To Next Page
Loading...
