DeWalt DCG409VS - DCG409 VS, DCG416 VS Accessory and Guard Applications; Surface Grinding; Cutting Off; Guidelines for Guards and Accessories for DCG409 VS, DCG416 VS

20
ENGLISH
Guard Types for DCG409VS, DCG416VS
Type B
(Shallow, Grinding)
Type A
(Closed cut off)
Type E
(Diamond surface grinding wheel
guard))

Type A (Type 41) guards are intended for use with Type 41(1A) cutting wheels and Type 42(27A)wheels marked for cutting only.
Grinding with wheels other than Type 27and Type 29require different accessory guards. Always use the smallest proper guard
possible that does not contact theaccessory.
NOTE: Type A (cut-off) and Type B (grinding) wheel guards where previously referred to as Type 1/41and Type 27wheelguards.
Additional Information for Guards and Accessories for DCG409VS, DCG416VS
When using segmented diamond wheels, use only
diamond wheels with a peripheral gap not greater than
10mm and negative rakeangle.
≤10 mm
DO NOT USE
segmented diamond wheels with a peripheral gap greater
than 10mm and/or a a positive rakeangle.
For all grinding, sanding, and wheel type wire brushing
accessories, the lowest portion of the accessory must
be contained within the guard enclosure with 2mm or
greater clearance to the bottom lip of guard
≥2 mm