DeWalt DCG413 - Accessory and Guard Compatibility; Guard and Accessory Application Guide

14
ENGLISH
Consult your dealer for further information on the
appropriateaccessories.
Max.
[mm]
[mm]
Min.
Rotation
[min.
–1
]
Peripherall
speed
[m/s]
Threaded
hole length
[mm]
D b d
d
D
b
115 6.4 22,23 11,500 80 –
125 6.4 22,23 11,500 80 –
D
115 – – 11500 80 –
125 – – 11500 80 –
D
d
b
75 30 M14 11500 45 20.0
D
115 13 M14 11500 80 20.0
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be replaced when it fails to
produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care
for our environment:
• Run the battery pack down completely, then remove it from
thetool.
• Li‑Ion cells are recyclable. Take them to your dealer or a local
recycling station. The collected battery packs will be recycled or
disposed ofproperly.
Additional Information for Guards and Accessories for DCG406, DCG413
When using segmented diamond wheels, use only
diamond wheels with a peripheral gap not greater than
10mm and negative rakeangle.
≤10 mm
DO NOT USE
segmented diamond wheels with a peripheral gap greater
than 10mm and/or a positive rakeangle.
For all grinding, sanding, and wheel type wire brushing
accessories, the lowest portion of the accessory must
be contained within the guard enclosure with 2 mm or
greater clearance to the bottom lip of guard.
≥2 mm