DeWalt DCN680 - Page 11

36
ENGLISH
Do not expose to water.
Have defective cords replacedimmediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indooruse.
Discard the battery pack with due care for
theenvironment.
Charge DeWALT battery packs only with designated
DeWALT chargers. Charging battery packs other
than the designated
DeWALT batteries with a
DeWALT charger may make them burst or lead to
other dangeroussituations.
Do not incinerate the batterypack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3batteries of 36 Wh).
Battery Type
The DCN680 operates on a 18 volt battery pack.
These battery packs may be used: DCB181, DCB182, DCB183,
DCB183B, DCB184, DCB184B, DCB185, DCB187, DCB546,
DCB547. Refer to Technical Data for moreinformation.
Package Contents
The package contains:
1 Nailer
3 Non-mar tips
1 Charger
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3 models)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
NOTE: N and NT versions are not supplied with batteries or
acharger.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Wear earprotection.
Wear eyeprotection.
Do not operate tool on scaffoldings,ladders.
Length ofnails.
Nailgauge.
Magazinecapacity.
Toolvoltage.
Magazine angle: 0˚.
Date Code Position (Fig. B)
The date code
18
, which also includes the year of manufacture,
is printed on the tool foot between the face of the battery and
thenailer.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Trigger
2
Trigger lock-off
3
Depth adjustment wheel
4
Headlights/low battery/
stallindicator
5
Jam clearing latch
6
Contact trip
7
Sliding magazine
8
Bump/sequential
selectorswitch
9
Reversible belt hook
10
No-mar pad
11
No-mar pad storage
12
Stall release lever
13
Nail depth indicator
14
Battery
15
Battery release button
16
Magazine latch
17
Low nail indicator
Intended Use
Your cordless finish nailer has been designed for driving nails
into woodenworkpieces.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
Your cordless finish nailer is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or