battery
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (Fig. 2)
NOTE: Make sure your battery pack(L) is fully
charged. The battery packs supplied will not
necessarily be fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the notch inside the tool’s handle with the
battery pack(L).
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button(O) and slide the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 2, 2A)
Some
battery packs include a fuel gauge
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the fuel
gauge button(P). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
NOTICE: Do not store tool with battery
pack installed. To prevent damage to
the pack and to ensure best battery life,
store battery packs out of the tool or
charger in a cool, dry location.
N. Speed selector switch
INTENDED USE
The DCN692 and DCN695 cordless framing nailers
have been designed for driving nails into wooden
workpieces.
The DCN692 cordless framing nailer is designed
for sequential/bump modes. This nailer is designed
for sequential/bump modes MUST NOT be
used on scaffoldings, stairs, ladders or ladder-like
constructions, e.g., roof laths. For exemptions
check your local national workplace regulations.
The DCN695 cordless framing nailer is designed for
sequential use only, whether in standard sequential
mode, or RapidCycle
sequential mode for faster
nailing. Nailers designed for sequential only mode
MAY BE used on scaffoldings, stairs, ladders or
ladder-like constructions, e.g., roof laths.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
These cordless nailers are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your
To Next Page
Loading...
