22
English
SYMPTOM CAUSE FIX
Jammed nail Wrong size or angle nails Use only the recommended nails. Refer to
Technical Data.
Magazine screws not secured after
previous jam clear/inspection
Make sure to tighten magazine hex bolts with
wrench provided.
Damaged or worn driver blade Replace driver blade. See authorised
repair agent.
Material and fastener length If the unit continues to stall (forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous an application.
Debris in nosepiece Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Worn magazine Replace magazine. See authorised
repair
agent.
Damaged pusher spring Replace spring. See authorised
repair
agent.
Dry fire lock out is engaged with only 7-9
nails remaining in magazine and the user
is applying excessive force to contact trip,
overriding the lockout
Load more nails in magazine to disengage dryfire
lockout.
Tool is not yet run-in New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
Use of incorrect speed. If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
TROUBLESHOOTING GUIDE (continued)
To Next Page
Loading...
