DeWalt DCR006 - Speaker Status and Volume; LED Speaker Status Indicator; Adjusting the Speaker Volume; Bluetooth Device Pairing

Page dimensions: 8.5 x 5.5 inches
11
English
2. Turn speaker on by pressing the power button (A). The LED (B)
will light solid for 4 seconds to indicate the apparatus powered on
successfully and then go into a half second interval blink pattern.
3. Press the Bluetooth
®
pairing button (C). The LED indicator light
blinks rapidly indicating the speaker is in pairing mode and is
discoverable by your Bluetooth
®
device.
4. Confirm pairing on your device. (Please consult your device's
instruction manual for specific pairing instructions.)
NOTE: If pairing is not confimed within 2 minutes, the LED will
stop flashing and the speaker will return to half second interval
blink pattern.
5. Once pairing is successful the LED indicator (B) will turn solid
and the speaker will emit a short tone. The speaker will now play
music from your device.
CONNECTING A PREVIOUSLY PAIRED BLUETOOTH
®
AUDIO
DEVICE (FIG. 1, 7)
If a Bluetooth
®
device has been previously paired to the speaker
it should automatically reconnect when speaker is powered on.
After 4 seconds the speaker will go into connecting mode. This is
indicated by the LED (B) blinking steady. Once the previously paired
Bluetooth
®
device is recognized and connected, the LED will go
solid. If connection does not occur and you are unable to stream
music please follow the instructions for Pairing Speaker with a
Bluetooth
®
Audio Device.
ADJUSTING THE SPEAKER VOLUME (FIG. 7)
The speaker volume can be decreased or increased by using the
corresponding volume buttons (E). Pressing the "VOL +" button
increases the volume. Pressing the "VOL-" decreases the volume.
LED SPEAKER STATUS INDICATOR
LED indicator Status/Mode
Steady blinking (half
second interval)
Speaker is unpaired or in connecting
mode.
Rapid Blinking Speaker is in pairing mode and
discoverable by your device.
Solid light Speaker is connected with a device.
No light Speaker has timed out and/or is off.
FIG. 7
C
E
E
D
B
A
PAIRING SPEAKER WITH A BLUETOOTH
®
AUDIO DEVICE
(FIG.6, 7)
1. Place the speaker and the Bluetooth
®
audio source within 3.3'
(1m) of each other.