To Next PageTo Next Page
Need help?Do you have a question about the DeWalt DCV580H and is the answer not in the manual?
General| Battery Voltage | 20V |
|---|---|
| Weight | 7.5 lbs |
| Filter Type | HEPA |
| Voltage | 20V |
| Hose Length | 5 ft |
| Type | Wet/Dry |
| Tank Capacity | 2 Gallons |
| Air Flow | 31 CFM |
| Power Source | Cordless |
| Air Volume (CFM) | 31 CFM |
Before use, ensure all users read and understand safety instructions. Save and review instructions frequently for guidance.
Do not use as a step ladder, placing objects on it, or blocking air vents. Keep away from moving parts.
Always wear safety glasses. Use face or dust mask if cutting is dusty. Wear certified safety equipment.
Be aware of dust from certain activities containing chemicals known to cause cancer or reproductive harm.
Recharge battery packs only with specified DEWALT chargers to avoid fire risks.
Use only DEWALT battery packs. Keep away from metal objects to prevent short circuits and fire.
Do not charge in explosive atmospheres, force packs, immerse in water, or store in extreme temperatures.
Use proper gauge extension cords for outdoor use. Ensure cords are not damaged or tripped over.
Do not incinerate. If contents contact skin or eyes, wash immediately with soap/water or flush with water.
Do not place objects on charger, use damaged cords, or connect multiple chargers. Use only 120V household power.
Understanding the red light indicators for charging status, pack charged, hot/cold delay, and problem conditions.
Troubleshooting charging issues based on fast flashing red light indicating problems with pack or charger.
Charge between 65-75°F (18-24°C) for longest life. Avoid extreme temperatures to prevent damage.
Battery packs may warm during charging. Avoid warm environments for cooling after use.
Cold Li-Ion packs charge slower. This rate persists even if the pack warms during the cycle.
Check receptacle, switch, temperature, or take tool/pack/charger to service center if problems persist.
Turn off, remove power head, unlatch tank, empty contents, and clean/change filters as needed.
The wet/dry filter must be installed correctly. Operate only with genuine DEWALT filters. Clean or replace as needed.
Empty tank, remove hose, insert hose into side exhaust port, and twist to secure for blower function.
Turn off and disconnect power before maintenance. Empty vacuum often. Keep fan area clean. Do not repair yourself.
Blow dirt from vents weekly. Use water/mild soap cloth, avoid solvents. Never immerse tool in liquid.
Disconnect charger before cleaning. Use cloth or non-metallic brush. Do not use water or cleaning solutions.
Only use DEWALT recommended accessories. A filter is available at extra cost at your local DEWALT service center.
Appliance functions as dust collector for power tools. Use DWV9000 adaptor for dust extraction.
Charger/battery packs are not serviceable. Repairs must be done by qualified DEWALT service personnel.
