Need help?Do you have a question about the DeWalt DE9000 and is the answer not in the manual?
General| Input Voltage | 120V AC |
|---|---|
| Output Voltage | 7.2V - 18V |
| Chemistry | NiCd, NiMH |
| Charging Time | 1 hour |
| Compatibility | 7.2V - 18V DeWalt batteries |
Read all instructions and cautionary markings on charger, battery pack, and product using battery pack.
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
Indicates a practice not related to personal injury which, if not avoided, may result in property damage.
230 volts present at charging terminals. Do not probe with conductive objects.
Do not allow liquid inside charger. Electric shock may result.
Charge only DEWALT batteries. Other types may burst, causing injury.
Children should be supervised to ensure they do not play with the appliance.
Keep metallic particles away from charger cavities. Unplug charger before cleaning.
Ensure supervision when inexperienced operators use the charger.
Not intended for persons with diminished abilities or lack of experience.
Do not operate with damaged cords or plugs. Take to authorized service centre.
Do not disassemble charger; take to an authorized service centre for repair.
Disconnect charger before cleaning to reduce electric shock risk.
NEVER attempt to connect two chargers together.
Charger designed for 230V household power. Do not use on other voltages.
Do not charge or use battery in explosive atmospheres with flammable liquids, gases or dust.
Charge only in DEWALT chargers. Do not splash or immerse in water.
Do not store or use where temperature exceeds 40 °C (104 °F).
Never attempt to open a cracked or damaged battery pack.
Do not incinerate battery pack even if damaged; it can explode in fire.
If battery contents contact skin, wash immediately with mild soap and water.
If battery liquid gets into eyes, rinse with water for 15 minutes or until irritation ceases.
Contents of opened battery cells may cause respiratory irritation. Provide fresh air.
Explains pictographs on charger and battery pack labels for proper identification.
DEWALT batteries comply with industry and legal shipping regulations.
Lithium-ion cells are tested to UN Recommendations.
Protect battery terminals from conductive materials to prevent short circuits.
Identifies the charger, charging indicators, and battery pack (Fig. 1).
Check battery pack voltage against rating plate and charger voltage against mains.
Charger is double insulated in accordance with EN60335; no earth wire required.
Instructions for safely fitting a new mains plug, including fuse recommendation.
Use approved cables with minimum 1 mm² conductor size and max 30 m length.
Check mains before charging. If no charge, take charger to authorized agent.
Charger and battery may become warm during charging; this is normal.
Do not charge below 4 °C or above 40 °C. Recommended temperature is 24 °C.
Red indicators blink according to charge state; all on when fully charged.
Table indicating battery pack charge state based on blinking lights.
Mode that equalizes individual cells for peak capacity; refresh weekly.
Suspends charging until battery reaches appropriate temperature for maximum life.
Protects against overloading, overheating, or deep discharge.
Product is not user serviceable; servicing required at authorized centre.
Unplug charger before cleaning. Keep ventilation slots clear.
Products and batteries marked with symbol must not be disposed of with household waste.
Recycle electrical products and batteries according to local provisions.
Run battery pack down completely, then discard with care for environment.
Li-Ion cells are recyclable. Take to dealer or local recycling station.
To Next Page
