DeWalt DW079 - Page 45

english
43
WALL MOUNT (FIG. 3)
aa. Mounting base
bb. Base mounting hole
cc. Mounting knob
dd. Scale
ee. Clamp locking knob
ff. Mounting holes
gg. Base leveling knob
hh. Locking knob
ii. Adjustment knob
Electrical Safety
The electric motor has been designed for various
voltages (see technical data). Always check that the
battery pack power corresponds to the voltage on
the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your DeWALT charger is double insulated
in accordance with EN 60335.
In case of cord replacement the tool must only
be repaired by an authorized service agent or by
qualified electrician.
Mains plug replacement
(U.K. & Ireland only)
DANGER:
 • Shouldyourmainsplugneedreplacing
and you are competent to do this,
proceedasinstructedbelow.Ifyouare
in doubt, contact an authorized D
eWALT
repairagentoraqualifiedelectrician.
 • Disconnecttheplugfromthesupply.
 • Cutoffthepluganddisposeofitsafely;
aplugwithbaredcopperconductors
is dangerous if engaged in a live socket
outlet.
 • Onlyfit13AmperesBS1363Aapproved
plugsfittedwiththecorrectlyratedfuse
(1).
 • Thecablewirecolours,oraletter,willbe
marked at the connection points of most
goodqualityplugs.Attachthewiresto
their respective points in the plug (see
below).BrownisforLive(L)(2)andBlue
is for Neutral (N) (4).
 • Beforereplacingthetopcoverofthe
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the cable
firmlyandthatthetwoleadsarecorrectly
fixedattheterminalscrews.
1
2
4
3
WARNING: NEVER use a light socket.
NEVER connect the live (L) or
neutral(N)wirestotheearth
pin marked E or .
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
Unpacking
FITTING THE WARNING LABEL
The safety warnings on the label shown on the laser
must be formulated in the language of the user.
For that purpose, a separate sheet of self-adhesive
labels has been supplied with the tool.
WARNING: Check that the safety
warningsonthelabelhavebeen
formulated in your language.
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 3R LASER PRODUCT
 • Ifthewarningsareinaforeignlanguage,
proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing
label.
– Press the label in place.
ASSEMBLY
WARNING: Priortoassemblyand
adjustment,alwaysremovethebattery
pack.Alwaysswitchoffthetoolbefore
inserting or removing the battery pack.