DeWalt DW300

9
English
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Cord not plugged in.
• Circuit fuse is blown.
• Plug tool into a working outlet.
• Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to blow,
discontinue use immediately and have it
serviced at a D
e
WALT service center or
authorized servicer.)
• Circuit breaker is tripped. • Reset circuit breaker. (If the product
repeatedly causes thecircuit breaker to
trip,discontinue use immediately and have
it serviced at a D
e
WALT service center or
authorized servicer.)
• Cord or switch is damaged. • Have cord or switch replaced at a
D
e
WALT Center or authorized servicer.