3
f) Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits, etc. in
accordance with these instructions, taking into account the
working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of
the power tool is maintained.
Electrical Safety
The electric motor has been designed for one voltage range only. Always
check that the power supply corresponds to the voltage on the rating
plate. 220–240 V AC means your tool will operate on alternating current.
Operation at a voltage outside this range can cause loss of power and can
result in overheating. All DeWALT tools are factory tested; if this tool does
not operate, check the power supply. Your DeWALT tool is double insulated,
therefore no earth wire is required.
Young children and the infirm. This appliance is not intended for use
by young children or infirm persons without supervision.
– This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
– Children should be supervised to ensure that they do not play with the
appliance.
Replacement of the supply cord. If the supply cord or plug is
damaged, it must be replaced by the manufacturer or an authorised
DeWALT Service Centre in order to avoid a hazard.
Extension Cords
CAUTION: Use only extension cords that are approved by the country’s
Electrical Authority. Before using extension cords, inspect them for loose or
exposed wires, damaged insulation and defective fittings. Replace the cord
if necessary.
Additional Specific Safety Rules for Planers
manual before operating planer.
adjustments with unit plugged in.
plug to a power source.
turn the switch OFF before restoring power.
instruction manual and check that all bolts are firmly tightened before
connecting unit to power source.
drugs, alcohol, or medication.
substances, in damp or wet locations, or expose to rain.
been shut off and cutter head has stopped rotating.
ALWAYS LOCATE PLANER WITH PROPER CLEARANCE ON
THE OUTFEED SIDE of the unit to prevent pinching or binding of the
workpiece against any obstacle.
containing metal particles often accumulate on interior surfaces and
To Next Page
Loading...
