18 en - 1
FLIP-OVER SAW DW742
Congratulations!
You have chosen a DEWALT product. Years of experience, thorough
product development and innovation make D
EWALT one of the most
reliable partners for professional users.
Table of contents
Technical data en - 1
EC-Declaration of conformity en - 1
Safety instructions en - 2
Package contents en - 3
Description en - 3
Electrical safety en - 4
Mains plug replacement (U.K. & Ireland only) en - 4
Using an extension cable en - 4
Assembly and adjustment en - 4
Instructions for use en - 6
Maintenance en - 8
Guarantee en - 8
Technical data
DW742
Voltage V 230
(U.K. & Ireland only) V 230/115
(Latin America only) V 120
Motor power (input) W 1,650
Motor power (output) W 1,100
Blade diameter mm 250
Blade bore mm 30
Max cycle of use load/no load min 1/3
No-load speed (50/60 Hz) min
-1
3,000/3,600
Saw head pre-set locations left/right ° 0-45
Bevel adjustment ° 0-45
Cutting capacities see under “Description”
Weight kg 38
Fuses:
Europe 230 V tools 10 Amperes, mains
U.K. & Ireland 230 V tools 13 Amperes, in plugs
The following symbols are used throughout this manual:
Denotes risk of personal injury, loss of life or damage to the
tool in case of non-observance of the instructions in this
manual.
Denotes risk of electric shock.
Sharp edges.
EC-Declaration of conformity
DW742
D
EWALT declares that these Power Tools have been designed in
compliance with: 98/37/EEC, 89/336/EEC, 73/23/EEC, EN 61029,
EN 55014-2, EN 55014, EN 61000-3-2 & EN 61000-3-3.
For more information, please contact D
EWALT at the address below or
refer to the back of the manual.
Level of sound pressure according to 86/188/EEC & 98/37/EEC,
measured according to DIN 45635:
DW742
L
pA
(sound pressure) dB(A)* 83
L
WA
(acoustic power) dB(A) 96
* at the operator’s ear
Take appropriate measures for the protection of hearing if the
sound pressure of 85 dB(A) is exceeded.
Weighted root mean square acceleration value according to DIN 45675:
DW742
-
TÜV Rheinland
Product and Safety GmbH (TRPS)
Am Grauen Stein 1
D-51105 Köln
Germany
Cert. No.
BM 9910081 01
Director Engineering and Product Development
Horst Großmann
DEWALT, Richard-Klinger-Straße 40,
D-65510, Idstein, Germany
ENGLISH
To Next Page
Loading...
