DeWalt DW936 - Cutting Depth Adjustment; Bevel Angle Adjustment

the work piece such as wire or nails can cause tips to crack or break.
Only operate saw machine when proper saw blade guard is in place.
Mount blade securely in proper rotation before using, and always use
a clean, sharp blade.
Cutting Depth Adjustment
1. TURN OFF TOOL AND REMOVE BATTERY PACK.
2. Hold the saw firmly and loosen (counterclockwise) the depth
adjustment knob and move shoe to obtain the desired depth of
cut.
3. Make sure the depth adjustment knob has been retightened
(clockwise) before operating saw.
For the most efficient cutting action, set the depth adjustment so that
one tooth of the blade will project below the material to be cut. This
distance is from the tip of the tooth to the bottom of the gullet in front
of it. This keeps blade friction at a minimum, removes sawdust from
8
English
0
1
5
20
30
40
5
0
SWITCH LOCK
OFF RELEASE
BUTTON
TRIGGER
SWITCH
SUPPORT
DO support board or
panel NEAR the cut.
FIG. 6
FIG. 7
FIG. 8
0
1
5
2
0
3
0
40
50
LOOSEN
clockwise
TIGHTEN
counterclockwise
BEVEL
ADJUSTMENT
KNOB
FIG. 4
FIG. 5
BLADE LOCK
BUTTON
DW936/384286-01 3/15/00 8:25 AM Page 8