DeWalt DW937 - Additional Safety Instructions for Battery Packs; Additional Safety Rules for Cutsaws; Labels on Charger and Battery Pack; Switching on and off

ENGLISH
en - 3 18
16 Remove the battery pack
Remove the battery pack when not in use,
before servicing and when changing accessories.
17 Have your tool repaired by an authorized
DEWALT repair agent
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety instructions for battery packs
Fire hazard! Avoid metal short circuiting
the contacts of a detached battery pack
(e.g. keys carried in the same pocket as
a battery pack).
• The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact,
flush immediately with water.
Neutralize with a mild acid such as lemon juice or
vinegar. In case of eye contact, rinse abundantly
with clean water for at least 10 minutes.
Consult a physician.
• Never attempt to open a battery pack for any
reason.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
100%
Battery charging
100%
Battery charged
Battery defective
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Use only with DEWALT battery packs,
others may burst, causing personal injury
and damage
Do not expose to water
Have defective cords replaced
immediately
+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
Additional safety rules for cutsaws
Switching ON and OFF
• After switching OFF, never attempt to stop the
saw blade with your fingers.
• Never put the saw down on a table or work
bench unless switched OFF.
When sawing
• When using saw blades specially designed for
cutting wood remove all nails and metal objects
from the workpiece before starting work.
• Wherever possible, use clamps and vices to
fasten the workpiece securely.
• Do not attempt to saw extremely small
workpieces.
• Do not bend too far forward. Make sure that you
always stand firmly, particularly on scaffolding
and ladders.
• Always hold the saw with both hands.
• For cutting curves and pockets, use an adapted
saw blade.
Checking and changing the saw blade
• Remove the battery before cleaning or changing
the saw blade.