DeWalt DWE1622 - DEWALT Magnetic Drill Press DWE1622; General Power Tool Safety Warnings; Electrical Safety Precautions

ENGLISH
5
Fig. C
16
19
19
20
Lubrication System (Fig. A, D)
Filling the Coolant Bottle

WARNING: Do not pour cutting fluid into the
bottle while mounted in the bracket. Do not
allow cutting fluid to enter the drill motor. Electric
shock mayresult.
NOTE: The lubrication system is designed for dispensing
cutting fluids specifically intended for drilling. Other liquids
may damage thesystem.
1. Turn the the flow regulator
13
counterclockwise to
close.
2. Remove coolant bottle
10
from magnetic bracket
5
.
3. Unscrew the cap
21
.
4. Fill the container with cutting coolant diluted
withwater.
5. Screw the cap back on.
6. Place coolant bottle into magnetic bracket
5
.
Fig. D
22
11
5
10
21
13
12
23
11
Fitting the Lubrication System
(Fig. A, D)

WARNING: Do not use the lubrication system in
vertical surfaces or overhead drilling applications.
Only use the lubrication system for horizontal drilling
applications, as shown in FigureA.
1. Place coolant bottle
10
into the magnetic bracket
5
,
then slide the magnetic bracket onto the either side of
the steel strip
22
.
2. Attach the coolant tube
11
to the coolant bottle:
a. Remove the nut
23
and thread it onto the tube
11
.
b. Slide the tube onto the nipple and tighten the
nut
23
.
3. Attach the tube to the coupling connector
12
on
thegearbox.
a. Remove the nut from the connector, then pass the
coolant tube
11
through the nut
23
.
b. Slide the coolant tube
11
onto the nipple to install,
then tighten the nut.
c. To remove, loosen the nut
23
, then pull the tube
from the connector.
In order to use the lubrication system, the coolant bottle
10
must be filled with a sufficient amount of cuttingfluid.
Lubrication in horizontal applications
(Fig. D)
1. Adjust the fluid flow as required using the flow
regulator
13
.
2. Add more cutting fluid if the shavings become blue.
Lubrication in Vertical and overhead
applications
Dip the cutter in cutting paste or apply an appropriatespray.
Fitting the Safety Chain (Fig. E)

WARNING: Always use the safetychain.
Feed the provided safety chain
9
through the handle of
unit and around the workpiece and secure in place.
Fig. E
9
15
Inserting and Removing an Accessory
(Fig. F, G)
The tool holder accepts annular cutters with a 3/4" shank
with two flats.

CAUTION: Laceration hazard. The cutter teeth
aresharp.
1. Slide the pilot pin
26
through the hole in the center of
the cuttershank.
2. Push up on the quick-release collar
24
.