DeWalt DWE4233 - General Power Tool Safety Warnings; Work Area and Electrical Safety

39
english
Fuses
Europe 230 V tools 10 Amperes, mains
U.K. & Ireland 230 V tools 13 Amperes, in plugs
Definitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to thesesymbols.
DANGER: Indicates an imminently
hazardous situation which, if not avoided,
will result in death or seriousinjury.
WARNING: Indicates a potentially
hazardous situation which, if not avoided,
could result in death or seriousinjury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
Denotes risk of electricshock.
Denotes risk offire.
EC-Declaration of Conformity
MACHINERY DIRECTIVE
SMALL ANGLE GRINDERS
DWE4233, DWE4227, DWE4237
DeWALT
declares that these products described
under Technical Data are in compliance with:
2006/42/EC, EN60745-1:2009+A11:2010,
EN60745-2-3:2011+A2:2013+A11:2014
+A12:2014.
These products also comply with Directive
2004/108/EC (until 19.04.2016), 2015/30/EU (from
20.04.2016) and 2011/65/EU. For more information,
please contact
DeWALT
at the following address or
refer to the back of the manual.
The undersigned is responsible for compilation of
the technical file and makes this declaration on
behalf of
DeWALT
.
Markus Rompel
Director Engineering
DeWALT
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
01.06.2015
WARNING: To reduce the risk of injury,
read the instructionmanual.
General Power Tool Safety Warnings
WARNING! Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result
in electric shock, fire and/or seriousinjury.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
The term “power tool” in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) powertool.
1) WORK AREA SAFETY
a) Keep work area clean and well lit.
Cluttered or dark areas inviteaccidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust
orfumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to losecontrol.
2) ELECTRICAL SAFETY
a) Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of
electricshock.
b) Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators. There
is an increased risk of electric shock if your
body is earthed orgrounded.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electricshock.
d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the
risk of electricshock.
e) When operating a power tool outdoors,
use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use
reduces the risk of electricshock.