DeWalt DWE4233 - Intended Use and Features; Electrical Safety and Connections; Electrical Safety Guidelines; Assembly and Adjustments

44
english
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the ratingplate.
Your D
e
WALT tool is double insulated in
accordance with EN 60745; therefore no
earth wire isrequired.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DeWALT
serviceorganisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the oldplug.
• Connect the brown lead to the live terminal in
theplug.
• Connect the blue lead to the neutralterminal.
WARNING: No connection is to be
made to the earthterminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm
2
; the maximum length
is 30m.
When using a cable reel, always unwind the
cablecompletely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
Attaching Side Handle (fig. 2)
WARNING: Before using the tool, check
that the handle is tightenedsecurely.
Screw the side handle(C) tightly into one of the
holes on either side of the gear case. The side
handle should always be used to maintain control of
the tool at alltimes.
INTENDED USE
The DWE4233,DWE4227 and DWE4237 heavy-
duty small angle grinders have been designed for
professional grinding, sanding, wire brushing and
cuttingapplications.
DO NOT use grinding wheels other than centre
depressed wheels and flapdiscs.
DO NOT use under wet conditions or in the
presence of flammable liquids orgases.
These heavy-duty angle grinders are professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use thistool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons withoutsupervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
thisproduct.
Anti-vibration Side Handle
The anti-vibration side handle offers added comfort
by absorbing the vibrations caused by thetool.
Dust Ejection System (fig. 1)
The dust ejection system (K) prevents dust pile-up
around the guard and motor inlet, and minimises the
amount of dust entering the motorhousing.
Soft Start Feature
The soft start feature allows a slow speed build-up
to avoid an initial jerk when starting. This feature is
particularly useful when working in confinedspaces.
No-Volt
The No-volt function stops the grinder restarting
without the switch being cycled if there is a break in
the powersupply.
Electronic Clutch
DWE4227
The electronic torque limiting clutch reduces
the maximum torque reaction transmitted to the
operator in case of jamming of a disc. This feature
also prevents the gearing and electric motor from
stalling. The torque limiting clutch has been factory-
set and cannot be adjusted.