TROUBLESHOOTING GUIDE
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D
eWALT SERVICE CENTER OR CALL 1-(800)-4-DeWALT.
WARNING: To reduce the risk of serious personal injury, remove
fasteners from canister before making any adjustments or servicing this tool.
SYMPTOM CAUSE FIX
Skipping nails; intermittent feed Air restricted Check air supply and couplers
Lack of lubrication Lubricate tool using D
eWALT pneumatic tool oil
Nosepiece screws loose Tighten nosepiece screws using appropriate hex wrench
Wrong size/angle fasteners Use only recommended fasteners
Dirty canister Clean canister tray and nosepiece
Damaged/Worn canister Replace canister
Broken or damaged driver blade Replace driver blade
Trigger valve o-ring worn or
damaged
Replace valve using Trigger Valve Kit
Worn piston o-ring Replace O-ring using Framing Nailer O-Ring Repair Kit
Fasteners jam in tool Driver channel in nosepiece worn Replace nosepiece
Wrong size/ angle fasteners Use only recommended fasteners
Worn driver blade Replace driver blade
Nosepiece screws loose Tighten nosepiece screws using appropriate hex wrench
Nails not feeding properly Ensure nails are feeding properly through the canister and into the nose
English
14
To Next Page
Loading...
Need help?
General
