DeWalt DWS771 - Protecting the Environment; Optional Accessories

ENGLISH
11
Cleaning
Before use, carefully check the upper blade guard, movable lower blade guard as well as
the dust extraction tube to determine that it will operate properly. Ensure that chips, dust or
workpiece particle cannot lead to blockage of one of thefunctions.
In case of workpiece fragments jammed between saw blade and guards disconnect the
machine from the power supply and follow the instructions given in section Mounting the
saw blade. Remove the jammed parts and reassembling the sawblade.

WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear approved eye protection and approved dust
mask when performing thisprocedure.

WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into aliquid.

WARNING: To reduce the risk of injury, regularly clean the tabletop.

WARNING: To reduce the risk of injury, regularly clean the dust collectionsystem.
Optional Accessories

WARNING: Since accessories, other than those offered by
DeWALT
, have not been tested
with this product, use of such accessories with this tool could be hazardous. To reduce the
risk of injury, only
DeWALT
, recommended accessories should be used with thisproduct.
Using the Roller Table (Fig. C–E)
The roller table
42
makes the handling of large and long pieces of wood very easy (Fig.E). It
can be connected either to the left or to the right of the machine. The roller table requires the
use of the optional legstand (Fig.C).

WARNING: Assemble the roller table following the instructions supplied with
thelegstand.
• Replace the short support bars provided with the legstand with the irregular rails from the
table on the side the table is to beused.
• Follow all instructions provided with the rollertable.
Range of saw blades available (recommended blades)
Type of blade Blade dimensions
(diameter x bore x no. of teeth)
Usage
DT4310 series 40 216x30x24 For general purpose, ripping and cross-cutting of wood and
plastics
DT4286 series 40 216x30x80 TCG for use with aluminum
DT4320 series 60 216x30x48 ATB for fine cutting of manmade and natural wood
DT4350 series 60 216x30x60 TCG for extra fine cutting of manmade and natural wood
Consult your dealer for further information on the appropriateaccessories.
Protecting the Environment
Separate collection. Products and batteries marked with this symbol must not be
disposed of with normal householdwaste.
Products and batteries contain materials that can be recovered or recycled
reducing the demand for raw materials. Please recycle electrical products and
batteries according to local provisions. Further information is available at www.2helpU.com.