To Next PageTo Next PageWhat to do if my DeWalt DWV010 motor does not run?
If the motor of your DeWalt Vacuum Cleaner isn't running, check the power cord, plugs, and outlet to ensure they are properly connected and functioning. Also, verify that the on/off switch is in the ON position and that the tool control is in the off position.
Why is my DeWalt Vacuum Cleaner suction capacity decreasing?
A decrease in suction capacity in your DeWalt Vacuum Cleaner may be due to several reasons: * There might be blockages in the suction nozzle, suction hose, or filters. If this is the case, remove any blockages. * The canister may need to be emptied or cleaned. Please refer to the Empty Canister operation instructions. * The filters may not be installed correctly. Ensure the filters are installed properly. * The filters may need to be replaced. Consider replacing the filters.
What to do if my power tool doesn't turn on the DeWalt Scrubber dust extractor?
If your power tool isn't turning on the DeWalt Scrubber dust extractor, first verify that the tool is properly plugged into the tool outlet. Then, make sure both the on/off switch and the tool control switch are in the ON position.
General| Power Source | Corded |
|---|---|
| Tank Capacity | 8 gallons |
| Hose Diameter | 1.25 inches |
| Filter Type | HEPA |
| Airflow | 130 CFM |
| Voltage | 120V |
| Type | Wet/Dry |
| Included Accessories | HEPA Filter |
Details the proper grounding method for the vacuum cleaner.
Guides users on how to turn the vacuum on and off and manage its functions.
Important safety advice and steps before performing wet pickup.
Instructions for removing, inspecting, cleaning, and installing HEPA filters.
Offers guidance to resolve typical operational problems with the vacuum.
