DeWalt DXGHT22 - Handle Adjustment Procedure; Adjusting Handle Position; Handle Mounting and Securing

15
ENGLISH
ASSEMBLY - Continued
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolts slightly (Fig. 4). Use a 5/32-
inch (4 mm) Allen wrench.
2. Hold the unit in the operating position (Fig.
13). Move the handle up or down the upper
shaft housing to a comfortable location (Fig.
5). Make sure the handle is positioned
beyond the end of the safety label (Fig. 5).
3. Tighten the bolts until the handle is secure.
Fig. 4
Fig. 5
Hole (x4)
Handle Top
Upper Shaft Housing
Bolt (x4)
Handle Base
Handle
Upper Shaft Housing
Safety Label