22
WARNING: DO NOT remove cut
material, or hold material to be cut,
while the blades are moving. Always
stop the unit before attempting to
remove debris or jammed material.
Allow time for moving parts to stop
after turning the unit o. Blades
coast for a short time.
Adjusting the Angle of the
Blade
1. Hold the angle adjustment handle (Fig. 15)
with the left hand. Hold the shaft housing
(Fig. 15) with the right hand.
ENGLISH
2. With the right thumb, push the adjustment
lever (Fig. 15) away from the indexing ring to
unseat the locking pin (Fig. 15).
3. Keep pushing the adjustment lever and
rotate the blade to the desired position
using the angle adjustment handle.
4. Align the locking pin with the desired
indexing hole in the indexing ring (Fig. 15).
5. Push the adjustment lever toward the
indexing ring to seat the locking pin in the
indexing hole and secure the blade in the
desired position.
OPERATION - Continued
WARNING: To avoid serious
personal injury, always stop the unit,
allow it to cool, and disconnect the
spark plug wire before adjusting the
blade angle.
Fig. 14
To Next Page
Loading...
