What to do if my DeWalt DXPW003E Pressure Washer motor fails to start?
If your DeWalt Pressure Washer motor isn't starting, first, ensure the plug is firmly in the socket and that the mains voltage supply is present. If the appliance hasn't been used for a long time, use the tool (M) to unjam the motor through the hole at the rear of the appliance (in models with this feature).
Why does the pump pressure drop suddenly during use of my DeWalt Pressure Washer?
A sudden drop in pump pressure during use of your DeWalt Pressure Washer can occur for a few reasons. If the water is being sucked from an external tank, connect the appliance to the mains water supply. If the inlet water is too hot, reduce the temperature. Check if the nozzle or the inlet filter is clogged and clean them.
How do I fix my DeWalt DXPW003E Pressure Washer when no detergent is being sucked in?
If your DeWalt Pressure Washer isn't sucking in detergent, make sure the adjustable nozzle is not on a high-pressure setting; set it to the " " setting. If the detergent is too dense, dilute it with water. If a high-pressure hose extension is being used, fit the original hose.
What causes a DeWalt Pressure Washer motor to buzz but not start?
If your DeWalt Pressure Washer motor buzzes but doesn't start, the power supply voltage might be too low. Check that the voltage of the mains power supply line matches the voltage on the plate. Also, voltage drop may occur due to the use of an extension cable, so check the characteristics of the extension cable.
Why is my DeWalt Pressure Washer so noisy?
If your DeWalt Pressure Washer is excessively noisy, the water may be too hot. Reduce the temperature according to the technical data.
What to do if my DeWalt DXPW003E (TSS version) has no water delivery when the gun trigger is depressed?
If your DeWalt Pressure Washer (TSS version) isn't delivering water when the gun trigger is depressed, the nozzle might be clogged. Clean the nozzle.
What causes water to escape from the thermo-stat valve of my DeWalt DXPW003E Pressure Washer?
If water is escaping from the thermo-stat valve of your DeWalt Pressure Washer, it means the water temperature inside the pump head has exceeded the maximum rated value stated on the nameplate. When the appliance is in operation, do not stop the water jet for more than 5 minutes at a time.
How to fix a DeWalt DXPW003E Pressure Washer when the pump does not reach working pressure?
If the pump on your DeWalt Pressure Washer isn't reaching working pressure, several factors could be the cause. Check if the nozzle is worn and replace it if necessary. Ensure the water filter is clean. Verify that the water supply is sufficient by fully turning on the water supply tap. Inspect hose fittings for tightness to prevent air from being sucked into the system. If there's air in the pump, switch off the appliance and repeatedly depress and release the gun trigger until a steady water flow emerges, then switch the appliance back on. Ensure the adjustable nozzle is correctly positioned on the (+) setting. Allow time for the correct water temperature to be restored if the thermostatic valve has tripped. Finally, reduce the suction height if water is being drawn from an open containe...
General| Power Source | Electric |
|---|---|
| Hose Length | 5 m |
| Voltage | 230 V |
| Motor | Universal |
| Motor Power | 1300 W |
To Next Page
