5
English (original instructions)
QUICK SETUP GUIDE
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual
before operating pressurewasher.
A
Install the Handle
Place handle onto frame, depress the snap buttons, and
slide the handle assembly onto the frame until snap
buttons snap intoplace.
B
Attach Battery Box Mounting Bracket
Align the holes in the battery box mounting bracket with
the holes in the frame. Push the saddle bolt through
the bracket and frame, secure with knob. Tighten
knobsecurely.
C
Add/Check Oil
The engine is shipped without oil. Before starting engine,
add the oil provided. Check oil level prior to each use. Refer
to Engine Owner’s Manual for completeprocedure.
D
Add Gasoline
In a well ventilated outdoor area add fresh, high quality,
unleaded gasoline with a pump octane rating of 86or
higher. Do not overfill. Wipe up spilled fuel before
starting the engine. Refer to Engine Owners Manual for
completeprocedure.
IMPORTANT: Ethanol Shield
™
(sold separately) is a fuel stabilizer that helps eliminate and prevent ethanol related
problems in power equipment. Follow the instructions on the container and add to thegasoline.
DANGER:
• Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an
odorless and deadlygas.
• Risk of fluid injection and laceration. When using the high‑pressure setting, DO NOT allow the high‑pressure spray to
come in contact with unprotected skin, eyes or with any pets or animals. Serious injury willoccur.
WARNING: Do not allow the unit to run for more than two minutes without the gun trigger being pulled. This
could cause overheating and damage to the pump. When the temperature inside the pump rises too high, the
thermal relief valve will open and release a spray of water from the pump to lower the internal temperature.
The valve will thenclose.
WARNING: To reduce the risk of electric shock or explosion, do not short circuit the battery terminals or charge in a
sealed container. Keep sparks and flame away. Do not use metal tools for connections and keep metal objects away from
the battery terminals. Metal objects can make a connection from one terminal to another. Shorting the battery terminals
together can cause sparks, burns, or afire.