OPERATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
1.Pull lid latches in an outward motion, remove power head and
some accessories that may have been shipped in the tank.
2.Attach heavy-duty rubberized casters following the instructions
in this manual.
3.Before replacing power head, refer to this manual to ensure
you have the proper filters installed for your cleaning operation.
4.Replace power head, and apply pressure with thumb to each
latch until it snaps tightly in place. Make sure all lid latches are
clamped secu
rely.
5.Insert the air hose end into inlet of tank.
6.Attach the extension wands to the accessory end of the hose.
Apply slight pressure until fitting is tight.
7.Attach one of the cleaning accessories (depending on your
cleaning requirements) on the extension wands. Twist slightly
to tighten the connection.
8.Plug the cord into the wall outlet. Your cleaniner is ready for use.
English
6
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter
out microscopic particles.
For your convenience and safety, the following warning labels are
on your vacuum.
ON MOTOR HOUSING :
WARNING:
SAVE THESE INSTRUCTIONS
• TO REDUCE THE RISK OF INJURY, USER MUST READ
INSTRUCTION MANUAL. DO NOT RUN UNATTENDED. DO
PU KCIP TON FLAMMABLE, COMBUSTIBLE OR HOT
MATERIALS. DO NOT USE AROUND EXPLOSI ,TSUD EV
LIQUIDS OR VA ECUDORP SECIVED LACIRTCELE .SROP
ARCS OR SPARKS WHICH CAN CAUSE FIRE
OR
EXPLOSION. DO NOT USE AT FILLING STATIONS OR
ANYWHERE GASOLINE IS STORED OR DISPENSED. DO
NOT VACUUM TOXIC OR CARCINOGENIC MATERIALS
OR OTHER HEALTH ENDANGERING MATERIAL SUCH
AS ASBESTOS OR PESTICIDES. ALWAYS USE PROPER
EYE AND RESPIRATORY PROTECTION. TO REDUCE THE
RISK OF ELECTRICAL SHOCK, DO NOT EXPOSE TO
RAIN. STORE INDOORS. WHEN SERVICING, USE ONLY
IDENTICAL REPLACEMENT PARTS. NOT TO BE USED
AS A STEP STOOL.
To Next Page
Loading...
Need help?
General
