English
WARNING:
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or a similarly
qualied person in order to avoid a hazard.
PROBLEM SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the oor
nozzle, extension wands, hose
or lter.
Replace the disposable dust bag.
Clean or replace the lter.
Empty dust tank, refer to TO EMPTY
THE TANK under OPERATING
INSTRUCTIONS.
Check for proper installation of
the lter.
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
Ensure lters are not damaged;
replace if necessary.
Ensure lter seals are in place and
are secure.
Check the t of the vacuum head.
Check for proper installation of the
lters.
Dust comes out
while vacuuming
YEAR
LIMITED
GUARANTEE
3
TOOL GUARANTEE
WARNING:
This product is NOT to be used for ltering of
pathogens, for example COVID-19. Follow all local,
state and federal guidance on general cleaning
practices.
22
To Next Page
Loading...
Need help?
General
