EasyManuals Logo

DeWalt DXV34P User Manual

DeWalt DXV34P
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
7
English
Storage (Fig. A)
1. Empty the canister, refer to Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
4. Store the suction hose and the power cord as
shown in the illustration. Place the unit in a dry
room and secure it from unauthorised use.
Blowing Feature (Fig. C)
Your vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
your vac as a blower.
1. Locate blowing port on your vac.
2. Insert one end of the 48mm x 2.1m hose
into the blowing port.
3. Turn vacuumON”.
Optional Accessories
WARNING: Since accessories, other than those
offered by D
EWALT, have not been tested with this
product, use of such accessories with this appliance
To reduce the risk of injury, only DEWALT
recommended accessories should be used with this
product.
CLEANING
TROUBLESHOOTING
WARNING!
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
customer service.
outside with a cloth dampened with warm water and
mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
WARNING! If the power cord is damaged, it must
be replaced by the manufacturer, its service agent or
PROBLEM SOLUTION
Motor does not run
Check power cord, plugs and outlet.
ON position ( I )
Remove blockages in the suction
Empty canister, refer to Empty
the tank under Operating.
instructions
Check for proper installation of the
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
switch to the ON position ( I ) to
test.
replace if necessary.
are secure.
Check for proper installation of the
Dust comes out
while vacuuming
®
B
10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DXV34P and is the answer not in the manual?

DeWalt DXV34P Specifications

General IconGeneral
BrandDeWalt
ModelDXV34P
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals