DeWalt XR DCD740 - Tool Setup and Operation; Intended Use

32
ENGLISH
Variable Speed Paddle Switch (Fig.A)
To turn the tool on, squeeze the paddle switch
1
. To turn the
tool off, release the paddle switch. Your tool is equipped with
a brake. The chuck will stop as soon as the paddle switch is
fullyreleased.
The variable speed switch enables you to select the best speed
for a particular application. The farther you squeeze the paddle,
Inserting and Removing the Battery Pack
from the Tool (Fig.B)
NOTE: Make sure your battery pack
9
is fullycharged.
To Install the Battery Pack into the Tool Handle
1. Align the battery pack
9
with the rails inside the tool’s
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap intoplace.
To Remove the Battery Pack from the Tool
1. Press the battery release button
10
and firmly pull the
battery pack out of the toolhandle.
2. Insert battery pack into the charger as described in the
charger section of thismanual.
Fuel Gauge Battery Packs (Fig.B)
Some DeWALT battery packs include a fuel gauge which
consists of three green LED lights that indicate the level of
charge remaining in the batterypack.
To actuate the fuel gauge, press and hold the fuel gauge
button
14
. A combination of the three green LED lights will
illuminate designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to berecharged.
NOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-userapplication.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury.

WARNING: Use only DeWALT battery packs andchargers.
Description (Fig.A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Paddle switch
2
Forward/reverse control button
3
Gear shifter
4
Deep hex pocket
5
Worklight
6
Belt hook
7
Mounting screw
8
Bit clip
9
Battery pack
10
Battery release button
11
Chuck with deep hex pocket
Intended Use
These drills are designed for professional drilling and
screwdrivingapplications.
DO NOT use under wet conditions or in presence of flammable
liquids orgases.
Date Code Position (Fig.B)
The date code
13
, which also includes the year of manufacture,
is printed into thehousing.
Example:
2021XX XX
Year and Week of Manufacture
Markings on Tool
The following pictograms are shown on the tool:
a
Read instruction manual beforeuse.
g
Wear earprotection.
f
Wear eyeprotection.
n
Visible radiation. Do not stare intolight.
Package Contents
The package contains:
1 Drill
1 Charger
1 Battery
1 Kitbox
1 Instruction manual
NOTE: Battery packs, chargers and kitboxes are not included
with N-models.
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
These drills are professional power tools. DO NOT let children
come into contact with the tool. Supervision is required when
inexperienced operators use thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.