EasyManua.ls Logo

DeWalt XR LI-ION DCB132 - Electrical Safety; Voltage Corroboration; Mains Plug Replacement (U.K. & Ireland Only); Plug Fitting Instructions

DeWalt XR LI-ION DCB132
132 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
54
BATTERY TYPE VOLTAGE CELL CAPACITY
DCB142 14,4 8 x Li-Ion 4,0 Ah
DCB143 14,4 4 x Li-Ion 2,0 Ah
DCB144 14,4 8 x Li-Ion 5,0 Ah
DCB145 14,4 4 x Li-Ion 1,3 Ah
DCB181 18 5 x Li-Ion 1.5 Ah
DCB182 18 10 x Li-Ion 4.0 Ah
DCB183 18 5 x Li-Ion 2.0 Ah
DCB184 18 10 x Li-Ion 5.0 Ah
DCB185 18 5 x Li-Ion 1.3 Ah
DCB546 18/54 15 x Li-Ion 6.0 Ah/2.0 Ah
DCB547 18/54 15 x Li-Ion 9.0 Ah/3.0 Ah
Electrical Safety
Always check that the battery pack voltage corresponds to the voltage
on the rating plate. Also make sure that the voltage of your charger
corresponds to that of your mains.
Your D
e
WALT charger is double insulated in accordance with
EN60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the
DeWALT
service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
Connect the brown lead to the live terminal in the plug.
Connect the blue lead to the neutral terminal.

Related product manuals