1.Disconnect from power source prior to opening the case.
2.Do not use the transformer with an extension cord.
3.Make sure all unused taps (leads) are separately insulated.
4.Do not install within 5 ft of a pool or spa.
5.Do not exceed total fixture load of 300VA.
Warning:
Product Layout
01
All wiring and installation must be in accordance with local
building and electrical codes. Always disconnect transformer
from power source before performing work on lighting system.
Calculate lighting capacity correctly – total load of fixtures
may not exceed 300VA.
High Voltage Wiring
Compartment
Ground Terminal
Low Voltage Wiring
Compartment
Circuit Breaker
Mounting brackets
To Next Page
Loading...
