04
2. Release the program button and then press it again. The indicator light
will be off. All the programming has been canceled.
1. Press the program button on the receiver for 6 seconds until the indicator
light starts to flash rapidly. (Note: The light flashes from slowly to rapidly.)
Programming the Receiver
The receivers and transmitters have been pre-paired for immediately use,
but there are few units may not be pre-programmed or programmed incorrectly,
or you want to customize the configuration to meet your needs.
To program a transmitter and receiver, please follow the steps below:
1. Press the program button on the receiver for 3 seconds until the indicator
light starts to flash slowly.
To Next Page
Loading...