Page 16 of 30
Dewhot | Gas geyser manual
The gas geyser temperature can be
regulated by adjusting the setting on the
front of the control panel. Safety factors
should be considered so please read and
follow the warnings outlined on page 8.
Mixers can be used to adjust the
temperature at the water outlet.
When the burner is switched on,
maximum water temperatures are
reached. The water temperature is
determined by turning on a hot water
tap. Water temperatures at the tap will
vary depending on the weather and
length of piping from the gas geyser,
the longer the run in pipe the cooler the
water will come out of the shower head.
Set the temperature as required by
pressing the UP or down arrows on the
temperature button (also see page 17).
By pressing the UP or DOWN you
buttons will adjust the temperature
point by 1°C increments.
Water Temperature settings
ON/OFF UP
DOWN
To Next Page
Loading...