Page 22 of 30
Dewhot | Gas geyser manual
Error code guide
WHEN AN ERROR CODE
IS DISPLAYED
• Close the hot water tap, turn o the
appliance and remove the battery.
• Wait for about 2 minutes before turning
it on again.
• Open the hot water tap.
IF THE ERROR CODE
REMAINS SHOWN
• Close the hot water tap and turn o the
switch on the LCD screen.
• Take the proper action shown below
and attempt operation of the appliance
again.
IF THE ERROR CODE IS
STILL SHOWN
• Turn o the hot water tap and turn o
the switch on the LCD.
• Take note of the error code displayed
and call the Dewhot Technical Service
number.
CAUTION
• For your safety DO NOT attempt to
repair any part of the gas geyser or
installation. Only a Registered LPG
Installer should do this.
• Turn o the power to the gas geyser
before removing protective cover.
Do not place any form of magnetized tool near the ow
sensor, this will damage it permananetly- remove the
battery when working on or near the ow sensor
To Next Page
Loading...