Dexcowin DX3000 - User Manual

Questions and Answers

E
erandallAug 10, 2025
What to do if nothing lights up on my Dexcowin DX3000?
- M
  Matthew KnightAug 10, 2025
  If nothing lights up on your Dexcowin Industrial Electrical, the cause might be a low battery. In this case, you should charge the battery.
S
scott85Aug 17, 2025
What to do if X-ray emission works, but exposure is too dark on my Dexcowin Industrial Electrical?
- E
  Elizabeth WilliamsAug 17, 2025
  If the X-ray emission works, but the exposure is too dark, there are several possible causes: * The receptor might be defective. Try changing the receptor or comparing it with another one. * The exposure time might be too long. Try decreasing the exposure time. * The device might be defective. In this case, call a qualified service technician.
T
Thomas CarterAug 25, 2025
What to do if X-ray emission works, but exposure is too light or completely white on my Dexcowin DX3000 Industrial Electrical?
- S
  Shelby FletcherAug 25, 2025
  If the X-ray emission works, but the exposure is too light or completely white, the following could be the reasons: 1. The receptor might be defective. Try changing the receptor or compare it with another one. 2. The exposure may be positioned incorrectly. Adjust the position of the exposure according to the user manual. 3. The exposure time might be too short. Increase the exposure time. 4. The device might be defective. In this case, call a qualified service technician.
W
westalyssaSep 1, 2025
Why is there no X-ray emission from my Dexcowin Industrial Electrical?
- C
  Carmen SmithSep 1, 2025
  If there is no X-ray emission, here are a few possible reasons: * The generator might be preparing an exposure. Wait for it to be ready, which usually takes about 5 seconds. * The device could be in “Remote” mode. Connect with a wired remote control, or change the “Exp Key Mode” to 'Right’ and ‘Left’ on the Setting function screen. * The button might be defective. In this case, call a qualified service technician.