What to do if nothing lights up on my Dexcowin iRay D3?
If nothing lights up on your Dexcowin Industrial Electrical, the cause might be a low battery. In this case, you should charge the battery.
What to do if X-ray emission works, but exposure is too dark on my Dexcowin iRay D3 Industrial Electrical?
If the X-ray emission works, but the exposure is too dark, there are several possible causes: * The receptor might be defective. Try changing the receptor or comparing it with another one. * The exposure time might be too long. Try decreasing the exposure time. * The device might be defective. In this case, call a qualified service technician.
What to do if X-ray emission works, but exposure is too light or completely white on my Dexcowin Industrial Electrical?
If the X-ray emission works, but the exposure is too light or completely white, the following could be the reasons: 1. The receptor might be defective. Try changing the receptor or compare it with another one. 2. The exposure may be positioned incorrectly. Adjust the position of the exposure according to the user manual. 3. The exposure time might be too short. Increase the exposure time. 4. The device might be defective. In this case, call a qualified service technician.
Why is there no X-ray emission from my Dexcowin iRay D3 Industrial Electrical?
If there is no X-ray emission, here are a few possible reasons: * The generator might be preparing an exposure. Wait for it to be ready, which usually takes about 5 seconds. * The device could be in “Remote” mode. Connect with a wired remote control, or change the “Exp Key Mode” to 'Right’ and ‘Left’ on the Setting function screen. * The button might be defective. In this case, call a qualified service technician.
General| Brand | Dexcowin |
|---|---|
| Model | iRay D3 |
| Category | Industrial Electrical |
| Language | English |
To Next Page
