Dexter Power NC1300CS - Specific Safety Rules for Laser; Laser Guide Usage

Dexter Power
19
EN
Original Instructions
d) Use the supplied saw blade only for cutting of wood, never for metal or plastic.
e) Longer period using may lead overheating the blade tips. Therefore take breaks of approx. 15 minutes on a regular basis to
let the blade tips cool down.
Specic safety rules for laser
The laser guide used in the tool is Class II with maximum output 1mW and wavelength 650nm.The laser guide do not normally
present an optical hazard, although staring at the beam may cause ash blindness.
LASER RADIATION DO NOT STEAR INTO BEAM
RADIATION LASER NE REGARDEZ PAS FIXEMENT LE FAISCEAU
LA RADIACIÓN DE LÁSER NO INYECTE DIRECTAMENTE AL RAYO
A RADIAÇÃO DE LASER NÃO INJETE DIRETAMENTE AO RAIO
LA RADIAZIONE DEL LASER NON FISSA IL RAGGIO
ΑΚΤΙΝΟΒΟΛΙΑ ΛΕΙΖΕΡ ΜΗ ΚΟΙΤΑΞΤΕ ΔΕΣΜΗ
PROMIENIOWANIA LASEROWEGO.NIE PATRZEĆ W WIĄZKĘ LASERA.
ЛАЗЕРНОЕ ИЗЛУЧЕНИЕ НЕ НАПРАВЛЯЕТ ЛУЧ В ГЛАЗА
ЛАЗЕРНОГО ВИПРОМІНЮВАННЯ НЕ НАПРАВЛЯТИ ПРОМІНЬ В ОЧІ
LAZER RADYASYONU INA GZLERINIZI DIKEREK BAKMAYN
RADIAŢIE LASER. NU PRIVIŢI FASCICUL.
EN60825-1:2014
Class 2 Laser Product.
CAUTION:
The use of optical instruments with this laser product will increase eye hazard
- Do not stare your eyes to the laser beam.
- The laser shall be used and maintained in accordance with the manufacture ’s instruction
- Never aim the beam at any person or an object other than the work piece
- Always ensure the laser beam is aimed at a sturdy work piece without reective surface. I.e. wood or rough coated surface
are acceptable. Bright shiny reective sheet or the like is not suitable for laser use as the reective surface could direct the
beam back at the operator.
- Do not change the laser light assembly with a different type. Any repairs must only be carried out by the laser manufacture or
authorized service agent.
- Do not attempt to repairs the laser guide by yourself
- Do not attempt to change any parts of the laser guide.
- Always switch off the laser when not used.