Why is my DGFLOW Control Panel pump's performance low?
If the DGFLOW Control Panel's pump performance is below the plate specifications, it could be due to air inside the suction manifold or a blocked/damaged pump. Bleed the suction system and inspect the pump to eliminate any blockages or damage.
How to fix a tripped circuit breaker on DGFLOW Control Panel?
If the current circuit breaker has tripped, it may be because the residual current circuit breaker is inadequate for the inverter supply. Replace the residual current circuit breaker with a model suitable for pulsating components and direct current (class A or B).
Why won't my DGFLOW Control Panel's VARIABLE SPEED pump start?
If the VARIABLE SPEED pump fails to start, several issues could be the cause. These include the pump being out of service, lack of water at suction, excessive overcurrent absorption, short circuit, no communication between control board and power board, no pressure signal, lack of phase during operation, wrong power wiring, no level signal, or the pump working dry. Here are a few things to check: * Put the pump back into service. * Check for water at suction, prime the pump, and clean the suction. * Check and correct the motor rotation and set the parameter PD to a lower value. * Check the correct current setting and voltage at pump terminals. * Ensure the motor is turning freely and there are no short circuits. * Check the integrity of the connection cable and connections. * ...
Core configuration parameters for initial setup.
Advanced parameters for optimizing system operation.
Configuration of signal inputs, outputs, and sensors.
Configuring system pressure and pump 1 rated current.
Accessing and modifying system parameters.
General| Brand | DGFLOW |
|---|---|
| Model | DGB MVF 30 |
| Category | Control Panel |
| Language | English |
To Next Page
