7
1-4 Hardware Setup/Installation
(1) Connect your WPCTV3000 device
(2) Connect the power adapter and push power button to turn on the WPCTV3000.
After few seconds, when you see the below screen: the device is assigned an IP address, the system is in
standby mode and ready to do file streaming or screen mirroring from your device. Please connect to
WPCTV3000 via Wi-Fi. Note: you can user your computers web browser to access advance setup
configurations by typing in the following IP address in the address bar of the browser:
This will give you the option to connect the WPCTV3000 to your home network and other advanced
settings
Note: To turn off the WPCTV3000 push the power button twice.
To Next Page
Loading...
Need help?
General
