Diamondback 64683 - Assembly Procedures

Page 8 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 64683
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
FEE6NSTH
GI%JK6!6MG%E6KLIPE%LMbPKH%;KIN%FOOLU6MGFT%IJ6KFGLIM-%
G'(8%$.*%J&)*(%E)"$4.%&2%$.*%$&&7%&22=%(*5&W*%$.*%E,2*$V%^*V=%,89%'8/7'3%$.*%$&&7%
2(&5%"$#%*7*4$("4,7%&'$7*$%+*2&(*%/*(2&(5"83%,8V%/(&4*9'(*%"8%$."#%#*4$"&81
M&$*- For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
L8#$,77"83%N&$&(%]*,9
1. Place three Screw Sleeves (128)
into top mounting holes on Water
Tray Frame (120) as shown.
2. Align the holes in the Motor Head
Assembly with the corresponding mounting
holes on the top of the Water Tray Frame.
3. Insert three M10 x 60 Socket Head Cap
Screws (131) through three Spring
Washers (130), Flat Washers (129),
the Motor Head Assembly, and the
Water Tray Frame. Secure using M10
Lock Nuts (127). Finger tighten.
4. Place two Screw Sleeves (128)
into side mounting holes on Water
Tray Frame as shown.
5. Insert two M10 x 60 Socket Head Cap
Screws (131) through two Spring Washers (130),
Flat Washers (129), the Motor Head Assembly,
and then into side mounting holes on the Water
Tray Frame. Secure using M10 Lock Nuts (127).
6. Tighten three previously installed M10 x 60
Socket Head Cap Screws securely.
7. With assistance, place the completed
Motor Head / Water Tray Frame
assembly on the Water Tray (77).
Q,$*(%
G(,V%
;(,5*
Q,$*(%G(,V%;(,5*
E4(*)%
E7**W*%
E4(*)%
E7**W*%
N&$&(%
]*,9%
F##*5+7V
M10 x 60
O,/%E4(*)
N>[%
T&4`%M'$
N>[%T&4`%M'$
;7,$%
Q,#.*(
E/("83%
Q,#.*(
M10 x 60
O,/%E4(*)
;7,$%
Q,#.*(
E/("83%
Q,#.*(
N&$&(%]*,9%L8#$,77,$"&8