Dickson DSB User Manual

DSB Quick Start Guide
What’s in the Box:
DSB Data Logger + Replaceable Sensor
(Sensor is sold separately and may be
different than pictured)
AA Batteries
Mounting Bracket & Hardware

Accessories:
Software, USB Stick, USB Cable
(sold separately, required for configuration and download)
AC Adapter
(optional accessory)

Replaceable Sensors
The DSB device works with Dickson’s replaceable sensors (sold separately), which are designed to eliminate downtime
and simplify recalibration of the device. Find more information at: DicksonData.com/replaceable-sensors

Getting Started With The DSB
The following steps will get you logging data quickly and easily:
1. Open the rear battery compartment door and add 2 AA batteries
2. Slide the replaceable sensor all the way into the port in the back
3. Press and hold the power button to power the device on. The display will indicate that it is loading; the current
firmware version number will then flash on the screen for a few seconds
4. Once powered on, you will see the most recent reading appear on the screen. You will need to configure the
device via Dicksonware (see “Configuring Device Settings Using Dicksonware”)

Dickson DSB Specifications

General

Measurement Range	-40 to 176°F (-40 to 80°C)
Accuracy	±0.9°F (±0.5°C)
Resolution	0.1°F/°C
Interface	USB
Operating Temperature	-40 to 176°F (-40 to 80°C)

Summary

What's in the Box

DSB Data Logger and Replaceable Sensor

The DSB Data Logger unit paired with a replaceable sensor.

AA Batteries

Two AA batteries included for powering the device.

Mounting Bracket and Hardware

Hardware for mounting the DSB device.

Accessories

Software, USB Stick, USB Cable

Required for configuration and data download.

AC Adapter

An optional accessory for powering the device.

Getting Started With The DSB

Initial Setup Steps

Steps to power on the device and insert batteries and sensor.

Navigating the Display

Display Elements Overview

Explanation of the different indicators and readings on the device display.

Configuring Device Settings Using DicksonWare

Sample Rate Configuration

Setting the data logging interval and display refresh rate.

Channels Configuration

Adjusting temperature units between Fahrenheit and Celsius.

Alarms

Setting Temperature and Humidity Thresholds

Configuring min/max thresholds for device alarms.

Downloading Data

Download to USB Stick

Procedure for downloading data onto a USB stick.

Download via USB Cable and DicksonWare

Procedure for downloading data using DicksonWare software.

Firmware

Firmware Update Information

Details on checking and updating the device firmware.

Using your DSB with the DicksonOne Legacy uploader

DicksonOne Legacy Uploader Functionality

Using the uploader to post data to a DicksonOne account.