• 4 •
2.6 Be extra cautious to reduce risk of
dropping a metal tool onto battery.
It might spark or short-circuit
battery or other electrical part that
may cause explosion.
2.7 Remove personal metal items such
as rings, bracelets, necklaces, and
watches when working with a lead-
acid battery. A lead-acid battery can
produce a short-circuit current high
enough to weld a ring or the like to
metal, causing a severe burn.
2.8 Use the charger for charging
only 6V and 12V LEAD-ACID
(STD, GEL, AGM or deep-cycle)
rechargeable batteries. It is not
intended to supply power to a low
voltage electrical system other than
in a starter-motor application. Do
not use battery charger for charging
dry-cell batteries that are commonly
used with home appliances. These
batteries may burst and cause injury
to persons and damage to property.
2.9 NEVER charge a frozen battery.
3. PREPARING TO CHARGE
3.1 If necessary to remove battery
from vehicle to charge, always
remove grounded terminal
from battery rst. Make sure all
accessories in the vehicle are off,
so as not to cause an arc.
3.2 Be sure area around battery is well
ventilated while battery is being
charged.
3.3 Clean battery terminals. Be careful
to keep corrosion from coming in
contact with eyes.
3.4 Add distilled water in each cell
until battery acid reaches level
specied by battery manufacturer.
Do not overll. For a battery
without removable cell caps,
such as valve regulated lead
acid batteries, carefully follow
manufacturer’s recharging
instructions.
3.5 Study all battery manufacturer’s
specic precautions while charging
and recommended rates of
charge.
3.6 Determine voltage of battery by
referring to car owner’s manual
and make sure that output voltage
selector switch is set at correct
voltage. If charger has adjustable
charge rate, charge battery initially
at lowest rate.
4. CHARGER LOCATION
4.1 Locate charger as far away from
battery as DC cables permit.
4.2 Never place charger directly above
battery being charged; gases from
battery will corrode and damage
charger.
4.3 Never allow battery acid to drip on
charger when reading electrolyte
specic gravity or lling battery.
4.4 Do not operate charger in a
closed-in area or restrict ventilation
in any way.
4.5 Do not set a battery on top of
charger.
5. DC CONNECTION PRECAUTIONS
5.1 Connect and disconnect DC
output clips only after setting any
charger switches to “off” position
and removing AC cord from
electric outlet. Never allow clips to
touch each other.
5.2 Attach clips to battery and chassis,
as indicated in sections 6 and 7.
To Next Page
Loading...
Need help?
General
