Why DieHard 71341 unable to keep battery fully charged?
If the DieHard Automobile Battery Charger was unable to keep the battery fully charged in maintain mode, it may be caused by a drain on the battery or the battery could be bad. Make sure there are no loads on the battery. If there are, remove them. If there are none, have the battery checked or replaced.
What to do if DieHard Automobile Battery Charger unable to reach full charge voltage?
If the battery was unable to reach the “full charge” voltage, it may be caused by trying to charge a large battery or bank of batteries on too low of a current setting. Try again with a higher current setting or have the battery checked or replaced.
What to do if the DieHard Automobile Battery Charger connections are reversed?
If the connections to the battery are reversed, it means the battery is connected backwards. Unplug the DieHard Automobile Battery Charger and reverse the connections to the battery.
What happens if DieHard Automobile Battery Charger detects a sulfated battery?
If the DieHard Automobile Battery Charger has detected a sulfated battery, it will go into desulfation mode. If the desulfation is not successful after 10 hours, the charger will go into abort mode.
What to do if DieHard Automobile Battery Charger cannot desulfate the battery?
If the DieHard Automobile Battery Charger cannot desulfate the battery, the battery could not be desulfated; have it checked or replaced.
Provides crucial safety and operating instructions to be followed before product use.
Essential safety rules including saving instructions, child safety, and weather exposure.
Warning regarding explosive gases generated during battery operation.
Prohibition of smoking or open flames near batteries.
Specifies compatible battery types and prohibits charging frozen batteries.
Procedure for safely connecting and disconnecting DC output clips.
Steps for connecting the charger to negative/positive grounded vehicle batteries.
Steps for attaching cables and clips, and safe positioning.
Requirements for grounding the charger and using a proper outlet.
Danger warning against altering the AC cord or plug.
Step-by-step guide for charging a battery while it is installed in a vehicle.
Step-by-step guide for charging a battery removed from a vehicle.
Guidance on using the charger to jump-start a vehicle.
Critical warnings and detailed steps for operating the Engine Start feature.
List of error codes, their descriptions, and solutions.
General| Brand | DieHard |
|---|---|
| Model | 71341 |
| Category | Automobile Battery Charger |
| Voltage | 12V |
| Maintain Amperage | 2A |
| Boost Amperage | 50A |
| Battery Type Compatibility | Standard, AGM, Gel |
| Microprocessor Controlled | Yes |
| Reverse Hook-Up Protection | Yes |
| Smart Charging | Yes |
| Overcharge Protection | Yes |
| Engine Start | Yes |
| Cable Length | 6 ft |
To Next Page
