2) Wash all parts with water and mild detergent
and rinse in water before placing in hot water
or sterilising. Check that there is no food left
inside. This is particularly important for the
heating element, as food can get trapped
behind the temperature measurement system
• Cleaning by boiling water: Bring sufficient water to the boil and
place the permitted items (table) in the boiling water for three
minutes
• Cleaning in the dishwasher: Clean the
permitted items (table) by placing these in the
top section of the dishwasher
• Cleaning using a (microwave) steriliser:
Follow the instructions on the steriliser.
(only place the permitted items in the
steriliser) (table)
Descaling the heating element
It is important to clean the heating element
C
thoroughly after
each use and to descale at least once every 3 months for optimal
operation. Regular descaling helps to remove limescale. Descaling
the heating element
C
prolongs the life of the heating element
and ensures the best possible heating results
Wash the heating element
C
with a mild detergent first and rinse
thoroughly. Fill a pan two-thirds with water and one-third with white
natural vinegar. We recommend using white natural vinegar because
Cleaning and sterilising instructions of the
Difrax S-bottle warmer
Disassemble the S-bottle warmer and clean this before each use
Regularly clean the base station
G
with a damp cloth.
Important: Never place the base station
G
and the plug
H
in water, a dishwasher or a steriliser, as this can cause
permanent damage to these parts
Important: The heating element
C
must NOT be placed in
boiling water or sterilised in an electric steriliser but or in a
microwave (steriliser)
1) Disassemble all parts, remember to remove the
O-ring valve
B
from the heating element
C
Damp
cloth
In
water
Dish-
washer
Electric
steriliser
Microwave
steriliser
A) Sealable cap
B) O-ring valve
C) Heating element
D-E) Bottle base
F) Protective cap
G) Base station
H) Plug
1110
To Next Page
Loading...